How do I get the dust and lint off the adhesive side of my glass protector? What if I find dust particles after applying my screen protector?
Assuming you see dust particles on the adhesive side before application:
- Hold the glass from the edges and avoid touching the adhesive side with your fingers to prevent more dust and fingerprints.
- Use the dust sticker to press firmly on the areas where dust is stuck and peel off to remove the dust particles. Repeat this for other dust particles, if any.
- Once all the dust is removed from the adhesive side, apply the screen protector.
If dust particles are found under the tempered glass after application:
- Avoid removing the entire screen protector to remove the dust particles after application.
- Find the edge closest to the dust particle and carefully peel it off. Use the dust sticker to press firmly on the areas where dust is stuck.
- Stick it back once all the dust is removed.
Related Articles
How to get rid of air bubbles under the protector?
Before installing the screen protector, remember to clean the screen before application and use the squeegee card after applying the protector. If bubbles are still there, use your finger to press on the bubble for a few seconds.
Can I re-apply Tempered Glass Screen Protector?
If misaligned during installation, the Tempered Glass can still be lifted and repositioned immediately. However, once the glue has adhered to the phone's screen for more than 12 hours, it cannot be reapplied.
Why did my tempered glass screen protector chip, crack or scratch within a few days of application?
Please note that scratches can occur due to accidental impacts or friction from everyday use of your device. Our warranty policy does not cover chipped, damaged, or scratched tempered glass. Tempered glass screen protectors are intended to provide an ...
There are weird lines and marks on the screen protector, making it hard to see clearly. What should I do?
Water marks can appear if excess water is not squeezed out or if insufficient solution is used. Lines may form if the water is squeezed out too aggressively. The solution marks will typically disappear within 3-4 hours once the device is fully dry. ...
Should I put tempered glass on a Gorilla Glass screen?
Yes, it’s recommended to use tempered glass on Gorilla Glass. Though Gorilla Glass is damage-resistant, it can still break at times due to accidental falls with great impact.